Viewing file:  ptrace.h (7.22 KB) -rw-r--r--
Select action/file-type:
 (+) |  (+) |  (+) | Code (+) | Session (+) |  (+) | SDB (+) |  (+) |  (+) |  (+) |  (+) |  (+) |
#ifndef _ASM_POWERPC_PTRACE_H
#define _ASM_POWERPC_PTRACE_H
/*
* Copyright (C) 2001 PPC64 Team, IBM Corp
*
* This struct defines the way the registers are stored on the
* kernel stack during a system call or other kernel entry.
*
* this should only contain volatile regs
* since we can keep non-volatile in the thread_struct
* should set this up when only volatiles are saved
* by intr code.
*
* Since this is going on the stack, *CARE MUST BE TAKEN* to insure
* that the overall structure is a multiple of 16 bytes in length.
*
* Note that the offsets of the fields in this struct correspond with
* the PT_* values below. This simplifies arch/powerpc/kernel/ptrace.c.
*
* This program is free software; you can redistribute it and/or
* modify it under the terms of the GNU General Public License
* as published by the Free Software Foundation; either version
* 2 of the License, or (at your option) any later version.
*/
#ifndef __ASSEMBLY__
struct pt_regs {
unsigned long gpr[32];
unsigned long nip;
unsigned long msr;
unsigned long orig_gpr3; /* Used for restarting system calls */
unsigned long ctr;
unsigned long link;
unsigned long xer;
unsigned long ccr;
#ifdef __powerpc64__
unsigned long softe; /* Soft enabled/disabled */
#else
unsigned long mq; /* 601 only (not used at present) */
/* Used on APUS to hold IPL value. */
#endif
unsigned long trap; /* Reason for being here */
/* N.B. for critical exceptions on 4xx, the dar and dsisr
fields are overloaded to hold srr0 and srr1. */
unsigned long dar; /* Fault registers */
unsigned long dsisr; /* on 4xx/Book-E used for ESR */
unsigned long result; /* Result of a system call */
};
#endif /* __ASSEMBLY__ */
#ifdef __KERNEL__
#ifdef __powerpc64__
#define STACK_FRAME_OVERHEAD 112 /* size of minimum stack frame */
/* Size of dummy stack frame allocated when calling signal handler. */
#define __SIGNAL_FRAMESIZE 128
#define __SIGNAL_FRAMESIZE32 64
#else /* __powerpc64__ */
#define STACK_FRAME_OVERHEAD 16 /* size of minimum stack frame */
/* Size of stack frame allocated when calling signal handler. */
#define __SIGNAL_FRAMESIZE 64
#endif /* __powerpc64__ */
#ifndef __ASSEMBLY__
#define instruction_pointer(regs) ((regs)->nip)
#define regs_return_value(regs) ((regs)->gpr[3])
#ifdef CONFIG_SMP
extern unsigned long profile_pc(struct pt_regs *regs);
#else
#define profile_pc(regs) instruction_pointer(regs)
#endif
#ifdef __powerpc64__
#define user_mode(regs) ((((regs)->msr) >> MSR_PR_LG) & 0x1)
#else
#define user_mode(regs) (((regs)->msr & MSR_PR) != 0)
#endif
#define force_successful_syscall_return() \
do { \
set_thread_flag(TIF_NOERROR); \
} while(0)
struct task_struct;
extern unsigned long ptrace_get_reg(struct task_struct *task, int regno);
extern int ptrace_put_reg(struct task_struct *task, int regno,
unsigned long data);
/*
* We use the least-significant bit of the trap field to indicate
* whether we have saved the full set of registers, or only a
* partial set. A 1 there means the partial set.
* On 4xx we use the next bit to indicate whether the exception
* is a critical exception (1 means it is).
*/
#define FULL_REGS(regs) (((regs)->trap & 1) == 0)
#ifndef __powerpc64__
#define IS_CRITICAL_EXC(regs) (((regs)->trap & 2) == 0)
#endif /* ! __powerpc64__ */
#define TRAP(regs) ((regs)->trap & ~0xF)
#ifdef __powerpc64__
#define CHECK_FULL_REGS(regs) BUG_ON(regs->trap & 1)
#else
#define CHECK_FULL_REGS(regs) \
do { \
if ((regs)->trap & 1) \
printk(KERN_CRIT "%s: partial register set\n", __FUNCTION__); \
} while (0)
#endif /* __powerpc64__ */
#endif /* __ASSEMBLY__ */
#endif /* __KERNEL__ */
/*
* Offsets used by 'ptrace' system call interface.
* These can't be changed without breaking binary compatibility
* with MkLinux, etc.
*/
#define PT_R0 0
#define PT_R1 1
#define PT_R2 2
#define PT_R3 3
#define PT_R4 4
#define PT_R5 5
#define PT_R6 6
#define PT_R7 7
#define PT_R8 8
#define PT_R9 9
#define PT_R10 10
#define PT_R11 11
#define PT_R12 12
#define PT_R13 13
#define PT_R14 14
#define PT_R15 15
#define PT_R16 16
#define PT_R17 17
#define PT_R18 18
#define PT_R19 19
#define PT_R20 20
#define PT_R21 21
#define PT_R22 22
#define PT_R23 23
#define PT_R24 24
#define PT_R25 25
#define PT_R26 26
#define PT_R27 27
#define PT_R28 28
#define PT_R29 29
#define PT_R30 30
#define PT_R31 31
#define PT_NIP 32
#define PT_MSR 33
#define PT_ORIG_R3 34
#define PT_CTR 35
#define PT_LNK 36
#define PT_XER 37
#define PT_CCR 38
#ifndef __powerpc64__
#define PT_MQ 39
#else
#define PT_SOFTE 39
#endif
#define PT_TRAP 40
#define PT_DAR 41
#define PT_DSISR 42
#define PT_RESULT 43
#define PT_REGS_COUNT 44
#define PT_FPR0 48 /* each FP reg occupies 2 slots in this space */
#ifndef __powerpc64__
#define PT_FPR31 (PT_FPR0 + 2*31)
#define PT_FPSCR (PT_FPR0 + 2*32 + 1)
#else /* __powerpc64__ */
#define PT_FPSCR (PT_FPR0 + 32) /* each FP reg occupies 1 slot in 64-bit space */
#ifdef __KERNEL__
#define PT_FPSCR32 (PT_FPR0 + 2*32 + 1) /* each FP reg occupies 2 32-bit userspace slots */
#endif
#define PT_VR0 82 /* each Vector reg occupies 2 slots in 64-bit */
#define PT_VSCR (PT_VR0 + 32*2 + 1)
#define PT_VRSAVE (PT_VR0 + 33*2)
#ifdef __KERNEL__
#define PT_VR0_32 164 /* each Vector reg occupies 4 slots in 32-bit */
#define PT_VSCR_32 (PT_VR0 + 32*4 + 3)
#define PT_VRSAVE_32 (PT_VR0 + 33*4)
#endif
#endif /* __powerpc64__ */
/*
* Get/set all the altivec registers vr0..vr31, vscr, vrsave, in one go.
* The transfer totals 34 quadword. Quadwords 0-31 contain the
* corresponding vector registers. Quadword 32 contains the vscr as the
* last word (offset 12) within that quadword. Quadword 33 contains the
* vrsave as the first word (offset 0) within the quadword.
*
* This definition of the VMX state is compatible with the current PPC32
* ptrace interface. This allows signal handling and ptrace to use the same
* structures. This also simplifies the implementation of a bi-arch
* (combined (32- and 64-bit) gdb.
*/
#define PTRACE_GETVRREGS 18
#define PTRACE_SETVRREGS 19
/* Get/set all the upper 32-bits of the SPE registers, accumulator, and
* spefscr, in one go */
#define PTRACE_GETEVRREGS 20
#define PTRACE_SETEVRREGS 21
/*
* Get or set a debug register. The first 16 are DABR registers and the
* second 16 are IABR registers.
*/
#define PTRACE_GET_DEBUGREG 25
#define PTRACE_SET_DEBUGREG 26
/* (new) PTRACE requests using the same numbers as x86 and the same
* argument ordering. Additionally, they support more registers too
*/
#define PTRACE_GETREGS 12
#define PTRACE_SETREGS 13
#define PTRACE_GETFPREGS 14
#define PTRACE_SETFPREGS 15
#define PTRACE_GETREGS64 22
#define PTRACE_SETREGS64 23
/* (old) PTRACE requests with inverted arguments */
#define PPC_PTRACE_GETREGS 0x99 /* Get GPRs 0 - 31 */
#define PPC_PTRACE_SETREGS 0x98 /* Set GPRs 0 - 31 */
#define PPC_PTRACE_GETFPREGS 0x97 /* Get FPRs 0 - 31 */
#define PPC_PTRACE_SETFPREGS 0x96 /* Set FPRs 0 - 31 */
/* Calls to trace a 64bit program from a 32bit program */
#define PPC_PTRACE_PEEKTEXT_3264 0x95
#define PPC_PTRACE_PEEKDATA_3264 0x94
#define PPC_PTRACE_POKETEXT_3264 0x93
#define PPC_PTRACE_POKEDATA_3264 0x92
#define PPC_PTRACE_PEEKUSR_3264 0x91
#define PPC_PTRACE_POKEUSR_3264 0x90
#endif /* _ASM_POWERPC_PTRACE_H */
|