Viewing file:  memreg.h (2.33 KB) -rw-r--r--
Select action/file-type:
 (+) |  (+) |  (+) | Code (+) | Session (+) |  (+) | SDB (+) |  (+) |  (+) |  (+) |  (+) |  (+) |
/* $Id: memreg.h,v 1.8 1996/08/29 09:48:23 davem Exp $ */
#ifndef _SPARC_MEMREG_H
#define _SPARC_MEMREG_H
/* memreg.h: Definitions of the values found in the synchronous
* and asynchronous memory error registers when a fault
* occurs on the sun4c.
*
* Copyright (C) 1995 David S. Miller (davem@caip.rutgers.edu)
*/
/* First the synchronous error codes, these are usually just
* normal page faults.
*/
#define SUN4C_SYNC_WDRESET 0x0001 /* watchdog reset */
#define SUN4C_SYNC_SIZE 0x0002 /* bad access size? whuz this? */
#define SUN4C_SYNC_PARITY 0x0008 /* bad ram chips caused a parity error */
#define SUN4C_SYNC_SBUS 0x0010 /* the SBUS had some problems... */
#define SUN4C_SYNC_NOMEM 0x0020 /* translation to non-existent ram */
#define SUN4C_SYNC_PROT 0x0040 /* access violated pte protections */
#define SUN4C_SYNC_NPRESENT 0x0080 /* pte said that page was not present */
#define SUN4C_SYNC_BADWRITE 0x8000 /* while writing something went bogus */
#define SUN4C_SYNC_BOLIXED \
(SUN4C_SYNC_WDRESET | SUN4C_SYNC_SIZE | SUN4C_SYNC_SBUS | \
SUN4C_SYNC_NOMEM | SUN4C_SYNC_PARITY)
/* Now the asynchronous error codes, these are almost always produced
* by the cache writing things back to memory and getting a bad translation.
* Bad DVMA transactions can cause these faults too.
*/
#define SUN4C_ASYNC_BADDVMA 0x0010 /* error during DVMA access */
#define SUN4C_ASYNC_NOMEM 0x0020 /* write back pointed to bad phys addr */
#define SUN4C_ASYNC_BADWB 0x0080 /* write back points to non-present page */
/* Memory parity error register with associated bit constants. */
#ifndef __ASSEMBLY__
extern __volatile__ unsigned long __iomem *sun4c_memerr_reg;
#endif
#define SUN4C_MPE_ERROR 0x80 /* Parity error detected. (ro) */
#define SUN4C_MPE_MULTI 0x40 /* Multiple parity errors detected. (ro) */
#define SUN4C_MPE_TEST 0x20 /* Write inverse parity. (rw) */
#define SUN4C_MPE_CHECK 0x10 /* Enable parity checking. (rw) */
#define SUN4C_MPE_ERR00 0x08 /* Parity error in bits 0-7. (ro) */
#define SUN4C_MPE_ERR08 0x04 /* Parity error in bits 8-15. (ro) */
#define SUN4C_MPE_ERR16 0x02 /* Parity error in bits 16-23. (ro) */
#define SUN4C_MPE_ERR24 0x01 /* Parity error in bits 24-31. (ro) */
#define SUN4C_MPE_ERRS 0x0F /* Bit mask for the error bits. (ro) */
#endif /* !(_SPARC_MEMREG_H) */
|